0 Items

Stryker Inflatable Boats Launching Wheel Install


  • 1×14 mm Socket Wrench
  • 1x Phillips Screwdriver
  • 1x Power Drill
  • 1×5/16 Drill bit


  • 4 x 50 mm Stainless Bolts
  • 4 x Washers
  • 4 x Locking Washers
  • 2 x Launching Wheels
  • 2 x Launching Wheel Brackets

Step 1

Fully inflate all the tubes then proceed to lift the transom approximately 10 inches off the ground.

Step 2

Place bracket on aluminum transom and measure 1.5 inches from tow bracket. (If you do not have a tow bracket measure 3″ from tube.)

Step 3

Drill your top hole then place a level against the side of your bracket while you mark you bottom hole. Remove bracket and drill bottom hole.

Step 4

Apply a ring of silicone around holes on bracket, then firmly press bracket into place and tighten down bolts.

Step 5

Place both brackets on the transom and firmly press down. Then proceed to tighten down both.

Step 6

Clip your wheels onto their brackets. You can also flip them up while in the water.